Atm Error Codes Pdf
Make sure all access panels are closed. Turn the AC power OFF for a few seconds and then back ON to power cycle and reset the cash dispenser. 3. The modem or the main board may cause the problem. Turn the AC power OFF for a few seconds and then back on to power cycle and reset the cash dispenser. http://msix.org/error-code/asd-error-codes.html
Inspect for a jammed currency in the reject sensor. 2. If this does not correct the problem, verify that the paper low sensor is correctly attached to the paper bracket and it is connected to the printer controller PCB. Error Code: 48 (30h) Description: Reject rate exceeded. Recommended Action: This error code is generated when a document from a note feeder fails to reach the note qualifier with in a specified time. http://www.atmexperts.com/atm_error_codes.html
Ncr Atm Error Codes
Test the dispensing mechanism by completing several Test Dispenses. 3. Restart the cash dispenser. Error Code: 119 (77h) Description: Diverter in dispense position on start of dispense or learn Recommended Action: 1.
- Verify that the currency is properly installed in the cassette.
- If the error clears, put the cash dispenser in service. 5.
- If the error persists, replace the dispensing mechanism.
Otherwise, replace the dispensing mechanism. Turn the AC power OFF for a few seconds and then back ON to power cycle and reset the cash dispenser. Remove the jammed documents as needed. Ncr Atm Presenter Error Clear terminal error BrowseInterestsBiography & MemoirBusiness & LeadershipFiction & LiteraturePolitics & EconomyHealth & WellnessSociety & CultureHappiness & Self-HelpMystery, Thriller & CrimeHistoryYoung AdultBrowse byBooksAudiobooksArticlesComicsSheet MusicBrowse allUploadSign inJoinWincore Error Codes.pdfUploaded by nag33ppPrinter
Error Code: 305(35h) Description: Diverter Failure. Ncr Atm Error Codes Manual Recommended Action: Inspect the feed path exit sensor for jammed documents and broken components. If the sensor is properly connected and operating correctly the CMC module may be defective. Verify that the both ends of each cable are securely connected to its termination points.
Error Code: 151 Description: Electronic Journal Full. Ncr Atm Hack Codes Error Code: 3 Description: BCD NOANSWER Possible Cause: Possible may be a processor or telephone hardware problem. Recommended Action: Check the dispenser data and power cable connections. Inspect the note diverter in the note transport module.
Ncr Atm Error Codes Manual
If the error does not show again put the cash dispenser into service. Results: No money is dispensed, screen and receipt display system unavailable. Ncr Atm Error Codes Clear terminal error code. Sbi Atm Error Codes PURGE the dispensing mechanism.
Make sure they are not overfilled. http://msix.org/error-code/aquarius-error-codes.html Complete several Test Dispenses to verify correct operation. Clear terminal error code. If the error clears, put the cash dispenser in service. 5. Ncr Atm Error Status Reference Guide
Replace the dispenser is the error persists. Baud rate set to high for telephone line conditions. Clear the error. this content At least one character was received (ETX was never received).
Modem response was good, but operation was not performed. 2. Triton Error Code 245 Recommended Action: Release the Printer Locking screw. Error Code: 163 Description: Terminal did not answer (Triton Connect error) Recommended Action: This error is not displayed at the cash dispenser.
Recommended Action: This error may occur anytime that a cassette is removed from the cash dispenser with the AC Power ON.
Error Code: 319(43h)[C] Description: Jam in note transport. If the error clears, put the cash dispenser in service. 6. Reset the error the error code. Ncr Error Code Translator Error Code: 160 Description: Electronic journal set featured failed.
The most probable cause is either mechanical or electrical failure of the note diverter in the note transport module. Otherwise, put the cash dispenser into service. If the error code is repeated, replace the note feeder or note feeder controller for the affected feed channel. have a peek at these guys The system returned: (22) Invalid argument The remote host or network may be down.