Atm Error Code 236
Restart operating system. Please try the request again. The system returned: (22) Invalid argument The remote host or network may be down. If the error clears, put the cash dispenser in service. 5. this content
If the error clears; put the cash dispenser in service. 4. If these actions have no effect on dispenser operation, replace the dispenser mechanism. Look for a reset entry directly after an incomplete transaction. 2. This error code is generated when there is a checksum error in data stored in the note cassette. http://www.accessatm.com/service/atm-error-codes/triton-error-codes/
Triton Atm Error Code 148
Clear the error. Remove any unacceptable currency from the cassette. 2. Open all access panels and inspect for jammed documents in note path between the note qualifier and note transport. If these actions have no effect on dispenser operation; replace the dispenser mechanism. 112 (70h) Timeout waiting for leading edge at reject A note that was expected to be seen by
- Make sure the ribbon cable from the docking station to the card reader is fastened at both ends of the cable and the orientation of the cable is correct. 4.
- It can occur if there are notes already in the transport before the start of a transaction or if the exit sensor is blocked. 1.
- Configuration jumpers may have been changed.
- Use the cash dispenser diagnostic functions to check the electrical operation of the sensor.
- Other components that may cause this error are the main board or the dispensing mechanism. 131 CTS (Clear To Send) line from the dispenser is not active. 1.
Once you have completed one of the above(more…) 152 Electronic journal corrupt 1. If the status clears and the return code are normal place the cash dispenser in service. Verify that the DC voltages to the dispenser are correct. Triton Error Code 101 Test the dispenser by completing several test dispenses with the test dispense command.
If the error recurs; change the note feeder for the affected channel. 320(44h)[D] Reject cassette almost full. Facebook Facebook LinkedInSearch Access © 2016: Access ATM, All Rights Reserved Access ATM, Inc. If the status clears and the return code are normal place the cash dispenser in service. http://www.atmdepot.com/triton-atm-error-codes/ Purge the dispenser.
Reset the cash dispenser and clear the error. Triton Traverse Error Code 917 If the problem persists; replace the dispenser. 48 (30h) Reject rate exceeded The most likely cause of this error is poor quality currency or an improperly adjusted dispensing mechanism. Make sure the diverter moves freely. 4. It may be necessary to replace the dispenser. 201 Dispenser detected more than six errors in a dispense This status is generated when there are 6 rejects during the current dispense.
Triton Error Code 244
Clear the error. 4. check my site If replacing the modem does not correct the problem, replace the main board. 138 Printer failed while printing to the receipt printer 1. Triton Atm Error Code 148 This error code occurs when the message received by the dispenser is incorrect. Atm Error Codes List The maximum withdrawal cannot exceed 50 time the denomination of the bill size in the cassette. 188 PIN working key not configured Enter the management functions and configure (download) the working
Check for and clear any foreign debris the note path. http://msix.org/error-code/at-t-error-code-6.html Purge the dispenser with the purge command under diagnostics. Verify that all access panels are closed and secured. 3. Remove any jammed notes.2. Triton Error Code 151
Check data and power connections to the dispenser device. Purge the dispenser using the purge command. If error persists; replace the dispenser mechanism. 389 Dispenser offline. http://msix.org/error-code/att-error-code-185.html If working with an 8100, print a test receipt printer, Verify that the A cassette is in service.
Access management functions and enable cassettes. 367 Dispenser communication error. Triton Error Code 616 Got connected and never received ENQ within time-out period (14 Seconds). (If problem persists call Your Service Provider or Triton Tech Support) 13 BGD_DONE_GOOD No money is dispensed; screen and receipt Results: If problem persists call Your Service Provider or Triton Systems Technical Support 95 Multiple cassettes of the same type This is a multi-cassette dispenser error. 1.
Make sure the connectors are seated securely on the main board and on the electronic journal. 4.
Look up the definition on the Hardware Status listing. 4. If the currency is in “fit” condition and the error persists, consider replacing the cassette or the dispenser. 199 Dispense width errors This status appears when the count at the exit If the error does not show again put the cash dispenser back into service. Triton Error Code 246 This error code will cause the cash dispenser to go ìOut of Serviceî.
If no jam is located; remove the first bill from the cassette. The upper RJ-45 port is used for downloading software only. If there is no visible damage and the connectors are attached to the sensor boards the best course of action is to replace the dispensing mechanism. 109 (6Dh) Time-out at Exit check my blog STEP 3: Click the "Repair All" Button to Repair Your PC!
Refer to error code 535. 540 Card Reader ñ Invalid message. Install the cassette. Clear the jammed documents. 2. Refer to error 500. 510 SPED invalid message ID.
If the problem persists, replace the dispensing mechanism. 133 +5 VDC not present on carrier detect 1. If the error clears, put the cash dispenser in service. 5. Verify correct operation with a live transaction. 3. Test the dispenser by completing several test dispenses. 3.
If the error clears, put the cash dispenser back in service. Make sure all ports on your gateway (connecting router) are open for bidirectional comms. 3. Inspect the cassette and feed path for jammed currency. Inspect the cassette and feed path for notes that are stuck together or jammed.
Verify that main board to electronic journal and the electronic journal to dispenser cables securely seated at both ends of the cable. Purge the dispenser using the purge command from diagnostic menu. 2. If the problem persists; replace the dispenser. 49 (31h) Jam at exit Inspect the feed path for jammed notes. Make sure the connectors are seated securely on the main board and on the electronic journal. 4.
Verify that the diverter moves freely and is not binding. Inspect card reader for foreign objects. This error code is returned by the dispenser when the number of notes in one or more of the cassettes is below a preset level; indicating the low level sensor in Other components that may cause this error are the main board or the dispensing mechanism. 144 No reply from the electronic journal. 1.
Otherwise, replace the dispenser. 39 Too many notes Clean the all sensors. Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 128 Error in reply from the dispenser mechanism 1. Put more currency in the cassette and repeat the “learn note thickness” command. This error code is produced when the single reject event counter exceeds 50 reject events or the bundle reject event counter exceeds 250 notes.