D0050 Transaction is not approved Code reported by host processor (Shazam). If the error persists, the vault assembly may need to be removed to inspect / access the cash tray sensors. Reset the cash dispenser by turning OFF the AC power switch for a few seconds and switching it back ON. C0048 Incorrect bill count Verify cash count in the Settlement menu. check over here
Check and reseat all belts. If the inject cassette ID function fails on a different cassette the CMC is defective. Recommended Action: Release the Printer Locking screw. Error Code: 108 (6Ch) Description: Unexpected note at double detect Recommended Action: A note has been detected in the double detect sensor without being detected at the width sensor first. 1. http://www.bankrate.com/finance/banking/atms-mistake.aspx
Atm Error Codes List
C004E Miscount of notes between sensors Test CDU using diagnostics, use journal to verify amount of dispensed notes versus requested notes. If replacing the modem does not correct the problem, replace the main board. 138 Printer failed while printing to the receipt printer 1. Inspect for a currency jam at the diverter. 2. Contact host processor D00A2 FS omitted (after available balance) Verify all programming.
Error Code: 114 (72h) Description: Exit blocked during purge Recommended Action: 1. Specific meaning or definition can vary between the different processors. Make sure the connectors are seated securely on the main board and on the electronic journal. 4. Atm Response Code 072 Once records have been viewed or saved, they need to be marked as audited.
D1800 No dial tone Verify that incoming phone line is plugged into "Line" rather than "Phone" on mainboard. The difference is just that in this case, the form/complaint cannot be handled locally. Check that Dual Master Key is disabled (non Coredata). http://www.howtutor.com/viewtopic.php?t=15 Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 107 Time out waiting for FIFO The dispenser is reporting the leading note has not cleared the
When troubleshooting the 8100, 9100, RL and RT be aware that the electronic journal is built into the main board of the dispenser. Atm Error Code 3-da000(80) Clear all errors and test the dispenser by completing several TEST DISPENSES. Otherwise, replace the dispenser. This error is usually associated with “”unfit”” currency or an empty cassette. 1.
- Check and reseat all belts.
- Clear the error. 3.
- Recommended Action: This error code is reported by the dispensing mechanism when a document is jammed in the throat sensor during a live dispenses or when a reset is performed.
- Error Code: 13 Description: BGD DONE GOOD Possible Cause: Communication was normal, but response header does not match request.
- Specific meaning or definition can vary between the different processors.
- One or two instances of this error does not usually indicate a defective part.
- Replace the dispensing mechanism. 53 EPROM error A mechanical failure has occurred.
- Recommended Action: Check data and power connections to the dispenser device.
- If the error persists in may be necessary to replace either the cassette or dispensing mechanism.
- Replace the dispenser is the error persists.
Atm Didn't Dispense Cash
Verify the physical presence of each cassette. http://www.accessatm.com/service/atm-error-codes/triton-error-codes/ If the error does not show again put the cash dispenser back into service. Atm Error Codes List If the error clears, put the cash dispenser back in service. Atm Error Code 3-da001 Inspect the feed path for any jammed notes.
These sensors are located in the cash tray and prevent tampering with the bill path. Error Code: 154 Description: Unknown electronic journal error code. Remove jammed currency. 2. Your Bank: You will need to contact your bank and explain what has happened. Atm Gave Me Extra Money
Purge the dispenser with the PURGE command. Verify that there is paper in the printer. Make sure the electrical connections to the timing wheel sensor are secure and the time wheel sensor is clean. Inspected both the feed sensor and the double detect sensor to ensure they are not blocked and operating correctly.
Check if CS62 sensor poll is abnormal. 3. Atm Ate My Money Deposit Error Code: 104 (68h) Description: Unable to clear width sensor. Other than upgrading the cash tray or using a sign to warn customers, you can loosen the screws that hold the dispenser and slide it back.
It the status clears, place the cash dispenser in service.
Check the calibration value for the pressure, empty, and exit sensors. Purge the dispenser using PURGE command. If a belt displays excessive wear or damage you may be able to replace it. Atm Cash Deposit Error If the error recurs, change the note feeder for the affected channel.
CDN0F CDU connection failure Check cables between CDU and Mainboard, remove cables (even though they may be attached) and re-connect. Reset the error code. C00D1 Sensor blocked while dispensing MB2100T - A blockage was detected between the CS12 (upper cash tray sensor) and CS14 (lower cash tray sensor). Recommended Action: See the recommended action for error code 128.
If the error clears, put the cash dispenser in service. 3. If the error clears, put the cash dispenser in service. D1900 No answer Verify host phone number - See D170x, there is no answer from the host modem. Contact your ISO or processor if you encounter an excessive amount of these errors, or you cannot complete a test transaction because of this error.
World's Most Exclus... If these actions have no effect on dispenser operation, replace the dispenser mechanism. Download to Triton Connect.