Atm Error Idc Error
Initialize after resetting the power2. Call your attendant 9701111BCC error of EPP1. Recommended Action: Restart the operating system. This problem may also be caused by a defective modem.
Check if the CIU communications serial cable is connected.3. Inspect the feed path for any jammed notes. Clean the pick up roller in the check cassette box.? Remove note from the CDU delivery path. 2. http://www.atmexperts.com/atm_error_codes.html
Ncr Atm Error Codes
Check if papre roll is set properly.2. Recommended Action: This error code is generated when the note transport sensor does not detect a note that was detected by the note qualifier. Check the number of dispensed notes. If the error persists in may be necessary to replace either the cassette or dispensing mechanism.
- JPR paper roll is out.
- Check second Dip Switch in Cash Dispenser B/D3.
- Verify that CS8 or encoder wheel sensor is in place and wire connection is good.
- Check dispensed check and reject check.2.
- Exchange Sensor after abnormal operating CS21B Sensor 4003FCS21A,CS21B DARK Detected(Initial recovery, Separated reject)1.
- Results: No money is dispensed, screen and receipt display system unavailable.
- Exchange Cash Dispenser B/D 40047001 cassette misfeed error (Separated rejection)1.
- Check if the CS11AB sensor cable is disconnected3.
- Recommended Action: See the recommended action for error code 128.
- If all programming appears correct, contact the processor … Modem connection error: Phone line connected to ATM will not support data … If you have an ATM machine with an Error
The cash dispenser will attempt to complete the transaction from other cassettes. Replace hard disk drive 9719200In case of carrying out Cash In Start command at two times1. Use an electrical parts contact cleaner on terminals. Atm Error Code 3-da001 Remove card 8218091PBM EXIST 9701010Failed to connect communication between SP of PIN and EP of one1.
Change CS5_2 Sensor 4003600 Error of CS 2, CS13 sensor during initialization 1. Sbi Atm Error Codes Check a check's status in the reject box2. If the error persists, replace the dispensing mechanism. Remove dust in CS1A, CS1B Sensor5.
Remove and refill the affected cassette using normal replenishment procedures. Atm Response Code 072 Error Code: 118 (76h) Description: Exit sensor blocked on start of dispense or learn Recommended Action: 1. Exchange Sensor after abnormal operating CS15A Sensor 4003C00 1 Cassette not available during dispense reserved operation 1. Error Code: 301(31h) Description: Low level in cassette.
Sbi Atm Error Codes
Check if the CIU power cable is connected. 90001Card Swipe Error.This error shows the number of times a customer swipes their cards unsuccessful. 97120Unable to create INI file 97121Unable to read http://chcatm.com/FAQ-pages/ATM-error-codes.htm Change Cash Dispenser B/D 4003400Error of two sheets detecting sensor(CS5_1)for initializing1. Ncr Atm Error Codes Initialize after removing the return path2. Hyosung Atm Error Codes Results: No money is dispensed, screen and receipt display system unavailable.
Try to inject an ID into another cassette. A0803 Receipt Paper Jam Remove jammed paper - Release receipt paper drawer by pressing the tab with the green sticker located at the front of the printer. Program the cassette by injecting a new cassette ID into the cassette. D0019 Reenter the entire transaction Code reported by host processor (Shazam). Ncr Atm Error Codes Manual
If the sensor is not being pressed then the error will occur. Recommended Action: See recommended action for error code 138. Call your attendant 977010Serial port open failCheck Cable / Device 1030100DEV_PIN (Key data error from host)1. Reset the receipt paper roll 2130300 Cutter regular position error in cut command (Receipt Printer) 1.
If error occurs when checking CS15 disconnection and operation, replace a sensor. 400AENo note in the tray before delivery or retract operation.1. Sbi Atm Response Code List Pdf If error occurs when checking CS 9 disconnection operation, replace a sensor. 9722100000Invalid Field (This Field's width is 0)1. Replace pinpad 9701152EPP is down when it receives an 'Clear Func Key' command1.
Check a check's status in the reject box2.
If persistent, it could be a defective modem. Initialize after Power On/Off 4. The system returned: (22) Invalid argument The remote host or network may be down. Atm Error Code 3-da000(80) ADN0F Printer connection error Check cables between Printer and Mainboard, remove cables (even though they may be attached) and re-connect.
Error Code: 139 Description: Printer controller not responding to commands. Error Code: 362 Description: Dispenser device write error. Rearrange notes in cassette3. If the sensor is blocked, remove the blockage.
Contact host processor D00A6 FS omitted (after total non cash dispense amount in day close) Verify all programming. This condition is also displayed on the configuration summary printout under "dispenser" as a lower case a, b, c, or d for the cassette in the low currency condition. Request has been sent. If the operation is normal, you may put the cash dispenser in service.
Remove note from the CDU delivery path. 2222200 The image is not black-white mode while its transmission period (Receipt Printer) 2333900 Comm. Verify that the DC voltages supplied to the dispensing mechanism are correct. Error Code: 339(57h)[W] Description: Error in throat. If the error clears, put the cash dispenser back in service.
C0056 Exit gate sensor failure Check condition of exit gate, and the exit gate sensor. Clean the exit sensor using a soft brush and a vacuum cleaner. NOTE: it is very common to see this error in the error summary and does not usually indicate a bad or defective part. Change the repeipt paper of receipt printer. 2001600 Note detected in stacker (shutter or presenter type) Clear any notes from the stacker. 2010100 In case of detecting to be open lever
It will be necessary to replace the note qualifier. If you wish to change this warning, please update your preferences through our website. Remove a dust on the CS13 sensor 40056Abnormal operation of the gate solenoid during dispense operation.1. You may need to remove the printer to clear jams.
Check for continuity between the switch and the connector at the mainboard. 20005 CDU Type Mismatch CDU ROM does not match AP software. Complete the test receipt printer function to determine which if any of the cassettes are not responding. If replacing the modem does not correct the problem, replace the main board. Recommended Action: This error code is generated by the dispensing mechanism when the calibration value for at least one of the sensors in any of the note feeders has exceeded the
Remove the remaining notes and foreign objects at the position of the CS11AB sensor 2.